Defender SN301-8CH Manuel d'instructions télécharger pdf (Page 9)

DFDVR2 7

2-4: POWERING ON

1. Insert the power supply wire into the rear DC 12V Port on the DVR.

2. Insert the power cord into the power supply.

3. Plug the power cord into a power outlet. We recommend using a surge protected power bar

and/or UPS backup (to turn the DVR on and off, use the power switch on your UPS or

power bar).

4. The DVR will power on and you will see a boot screen. After the DVR initializes you should

see a 4 camera QUAD view, and recording will begin immediately.

POWER SUPPLY

POWER CORD

DC 12V PORT

1. We strongly recommend that you change the following settings as soon as you

power on the DVR ( see section 4-4-5 for detailed instructions):

(A) Set up the time/date.

(B) Go to the HDD management and FORMAT HDD. This will clear the video you

recorded after power on and avoid any time/date discrepancies.

2. DO NOT change the date and time after the recording starts. It may corrupt the

DVR’s data archive and cause playback errors. If it is necessary to change date and

time after the recording starts, please repeat step 1 to avoid errors.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 74 75

Pas de commentaire

Defender SN301-8CH Manuel d'instructions Page 9