Defender SN301-8CH Manuel d'instructions télécharger pdf (Page 41)

DFDVR2 39

Step 5:

Select In the Add New Port Forward Entry screen, proceed as follows:

- In the Template eld, select Custom

- In the Name eld, select DVR

- In the Port Start eld, enter the rst number of the port you need to port forward (e.g. 50000).

- In the Port End eld, enter the ending port number (e.g. 50000).

- In the LAN IP Address eld enter the IP address (192.168.0.1).

- Check the Enable button

- Finally, click the Add button, followed by selecting the Apply button.

Port forwarding is now complete for the Motorola router!

6-2-9: TWO-WIRE ROUTER

The port forwarding process may vary depending on the brand and model number of the

router being used. Port forwarding of a router is required to allow user access to your DVR.

Regardless of the Two-Wire Router being used, the process of port forwarding is similar. You

will need to enable the ports by locating the port range forwarding screen (Note: in many two

wire systems, it is located in the rewall setting). The set up instruction outlined below is an

example of port forwarding a Two-Wire Router using the Two-Wire Model 1500000G.

Step 1:

Open your web browser. Enter the router IP address 192.168.1.254 in the address bar,

followed by pressing Enter.

Step 2:

Select the Firewall Tab.

Step 3:

Select Firewall Settings.

Step 4:

In the Edit Firewall Settings tab, select add a new user dened application.

Step 5:

- In the Edit Firewall Settings proceed as follows:

- In the Select a Computer eld, select DVR.

- In the Edit a Firewall Setting, check the Allow Individual Applications box and highlight

the DVR application which you just created. Click Add.

Step 6:

- Select the Back button to return to the Edit Firewall Screen

- In the Edit Firewall Settings proceed as follows:

- In the Application Name eld, type DVR.

- In the Protocol selection, select TCP.

- In the Port eld, enter in the rst box, the rst number of the port you need to port

forward (e.g. 50000) and in the second box the ending port number (e.g. 50000).

- Select the Add Denition button.

- Finally select the Done button at the bottom of the screen.

Port forwarding is now complete for the Two-Wire Router!

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 74 75

Pas de commentaire

Defender SN301-8CH Manuel d'instructions Page 41