Defender PHOENIX1 Manuel d'instructions télécharger pdf (Page 10)

PHOENIX1

6PHOENIX1

SETTING THE CAMERA CHANNELS

1. Verify the camera’s channel setting by verifying the DIP switch settings. To do this, unscrew the front part of the

cameratoopenthelenscoverandadjusttheDIPswitches.PHOENIX1camerasaresetbydefaulttoChannel1.

2. UseapenorpointedobjecttoiptheDIPswitchesupordownaccordingtotheimagebelow.Makesurethatone

camera is set to the Channel 1 position and the other camera is set to the Channel 2 position.

3. Accordingly,theDIPswitchlocatedonthebottomofthemonitorshouldbeadjustedtoreecttheuseofmultiple

channels.Themonitorwillbesetbydefaulttochannel1only.Tobeabletoviewbothcamerasyouneedtoadjust

theDIPswitchesonthebottomofthemonitortoreectallchannelsinuse.

4. UseapenorpointedobjecttoiptheDIPswitches

down according to the image (right). This way the

monitor will be able to display video from both cam-

eras.

Note: This is very small and may be hard to see. Appropriate lighting needed

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Pas de commentaire

Defender PHOENIX1 Manuel d'instructions Page 10